May 12, 2010

Plus Size Pillow Case Apron Tutorial




Today's tutorial is from the lovely Pam of Warm Hugs Designs.  She created this tutorial and then contacted me to let me know so I could share it with all of you:)  So... if you happen to write a vintage sheet tutorial would love to post it here, so email me!


Ok, you've seen the tutorial on how to make a pillowcase apron using a standard pillowcase - and it's a great thing! But how about us plus size gals? I need a bit more material to go around, if you know what I mean. So, I designed a Plus Size Pillowcase Apron and made this tutorial.

You will need an extra long pillowcase (mine shown is approximately 38" long), your sewing machine, and an iron. I've used the extra material cut from this pillowcase to make the waistband and ties or you could save time by using approximately 3 yards of ribbon. I also added some vintage eyelet, but adding trim is optional. Rickrack would look great too as a trim! So let's get started:


Step 1: Lay out your pillowcase flat length wise (length is horizontal). Cut at approximately 28 1/2" for a size 18/20 gal. (you can cut at different widths depending on how much material coverage you want).


Step 2: Turn in edges where you just cut 1/2" and press to make a finished side edge. Machine stitch 1/4" seam along this edge.


Step 3: Fold bottom up approximately 7 1/2". This will be the pockets. If you want to add a decorative trim before sewing together go to next step. If not adding a trim go to Step 5.


Step 4: Pin in place decorative trim



Turning ends on side then machine stitch trim. This will be the top edge of pocket.


Step 5: Machine stitch along sides and bottom of apron starting on right side going down edge using 1/4" seam. Then pin where you want to stitch the pockets. Make sure the apron is flat and begin stitching from bottom to stitch your pocket seams. I've stitched two seams approximately 1/3 from each side giving this apron three large pockets. Don't forget to back stitch at top of pocket to reinforce these seams.

The apron base is now complete - just have to add a waistband and ties!


Step 6: I've cut the extra pillowcase material to make my own waistband and ties. Measure the width of the apron to make the waistband and then use the remaining for the ties. I iron the strips of pillowcase material together and then stitch a seam close to the edge. Then stitch the ties to the waistband. I made these extra long so I can bring back around to front and tie. You can make the ties shorter and tie in back - very cute too! Making the ties and waistband this way is a bit more work but I like the look. If you don't have enough extra material from the pillowcase you can use a vintage sheet or your favorite ribbon!


Step 7: Now stitch all along the edges of the waistband onto the apron.



My finished apron is approximately 28" wide by 13" long (the standard pillowcase apron is only 20" wide). It has three deep pockets to hold all kinds of things. I'll use mine while doing a craft show to hold my money, cell phone, and glasses. When I'm at home I'll put my clothes pins in the pockets when I hang out my laundry. How will you use yours?




Thanks Pam for a fun tutorial!!!

1 comments:

Warm Hugs Design said...

You are so welcome. Hope the instructions are clear - contact me if you have any questions...

Warm hugs,
Pam